Knowledgebase
|
Sometimes Spyder3Print asks me to calibrate my Spectro before reading patches, and other times it does not. Why does this occur?
Posted by Larisa Bolli on 27 July 2009 12:49 PM
|
|
| Spyder3Print requires you to calibrate your Spectro the first time you run through the wizard after launching the application. It will not require recalibration unless you leave the application open for more than four hours, or quit and restart the application. You can choose to recalibrate at any time by going to the Tools menu, and choosing the Calibrate command. | |
|
|